Most satellite internet gear is built to look like it belongs on a military truck. WaterField Designs, the San Francisco bag maker, went the other way with its new Starlink Mini Go Case, and its own pitch for it is short: professional, not tactical. It is a waxed canvas and leather carry case that looks at home in a hotel lobby or a coworking space, and it holds the dish, the power brick and every cable in one place.
That case is where this guide starts. From there we go through everything a Starlink Mini owner actually needs: cases and bags, batteries and power stations that can run the dish, the right cables and car adapters, mounts for roofs, poles and vehicles, and a few extras for weather and Wi-Fi. Every spec here comes from the maker's own product page, spec sheet or manual. At the end you will find three ready-made kits for van life, remote work and camping.
First, the numbers that matter
Before you buy any accessory, know what the dish needs. According to Starlink's official Mini spec sheet, the Mini measures 298.5 x 259 x 38.5 mm and weighs 1.10 kg, or 1.16 kg with its kickstand. It is rated IP67 with the cable installed, works from minus 30 to 50 degrees Celsius, and draws an average of 25 to 40 watts. The input rating is 12 to 48 volts at 60 watts.
The figure that decides which batteries work is the USB-C requirement. Starlink says the Mini needs a USB Power Delivery source of at least 100 watts at 20 volts and 5 amps when you use its USB-C to barrel jack cable. A 3 amp port only gives 60 watts at 20 volts. Read the label next to the port, not the headline.
The lead: WaterField Starlink Mini Go Case
The Starlink Mini Go Case is a two compartment carry case made for the Mini and everything that comes with it. One padded compartment holds the dish, with or without the bumper and sleeve from Starlink's own Mini Travel Kit, and WaterField says it also fits the Mini with an integrated power bank attached. Firm foam lines the bottom, front and back to cushion it against knocks.
The second compartment is for the rest of the kit. Stretch mesh pockets are sized for three different setups, which WaterField lays out on the product page:
- Power Car User: power brick and cord, car adapter and suction cup car mount.
- Overlander or Traveler: power brick and cord, car adapter, suction cup car mount and Ethernet cable.
- Remote Worker: power brick and cord, Ethernet cable and Router Mini.
The detail we like most is the cord pass-through. You can leave the dish outside on a table or a roof while the brick, cables and battery stay zipped up inside the case, so nothing gets lost in the grass. The case ships with two leather cord clips for the long 15 meter cable, a bright gold nylon liner so you can see what is inside, and water resistant YKK zippers.
It comes in two builds: 15 oz waxed canvas with chocolate full grain leather, or 1680 denier ballistic nylon with black leather. Both measure 11.5 x 3.75 x 12.5 inches. The nylon version weighs 1.25 pounds and the canvas version 1.5 pounds. WaterField also sells an optional 1 inch Supreme Suspension shoulder strap for over the shoulder carry. It pairs well with anything from our carry-on travel backpack guide.
Cases and bags
Starlink Mini Travel Kit. Starlink's own Mini Travel Kit is the budget path to protection, and it pairs well with the WaterField case. Starlink describes three pieces: a custom fitted bumper case for drop protection, a sleeve that doubles as a carrying case and shields against dirt and scrapes, and an accessory pouch that fits all the components you need to power the Mini. The kit box measures 298 x 318.5 x 46 mm and weighs 0.75 kg.
Veritas Vans Hard Travel Case for Starlink Mini Mount. If you run a Veritas Vans mount, the San Luis Obispo company makes a custom designed hard travel case built around it. Veritas says it fits its Starlink Mini mount and all of the accessories, even with the handle installed, and there is room for the magnets, the suction cups and even your laptop. It is the pick if you move the whole mount setup between vehicles instead of just the dish.
Power: batteries and power stations that can run the Mini
This is where most Mini owners get stuck. The dish averages 25 to 40 watts, but it needs a source that can deliver 20 volts at 5 amps over USB-C. All four options below list that on their official pages or manuals.
BigBlue POWAFREE 3. The POWAFREE 3 is built specifically for the Mini. BigBlue lists a 99Wh battery, a built-in kickstand and clip-on design, pass-through charging, and a dedicated DC5521 cable for the dish. Its USB-C port outputs up to 100 watts at 20 volts and 5 amps, so you can charge a phone or laptop from the same pack. BigBlue says it runs the Mini for over 4 hours and recharges in about 2 hours over USB-C. At 99Wh it sits under the common 100Wh carry-on limit.
Jackery Explorer 100 Plus. The Explorer 100 Plus is a palm sized LiFePO4 power station. Jackery's official manual lists 99.2Wh, a weight of about 965 g, and two USB-C ports each rated 100 watts with 20 volts at 5 amps. It is rated for 2,000 cycles to 80 percent capacity and recharges at up to 100 watts over USB-C, from the wall, a car or solar.
Anker SOLIX C300 DC. For longer days, the SOLIX C300 DC steps up to 288Wh and 300 watts of output. Anker lists two 140 watt two-way USB-C ports and up to 100 watts of solar recharging. Use one of the 140 watt ports for the dish and keep big draws off the other ports while it runs. At 288Wh it is a car, van and camp choice.
Starlink Mini Car Adapter. If your vehicle is your battery, the official Mini Car Adapter is the cleanest answer. Starlink says it powers the Mini over USB-C from any standard 12 to 24 volt auxiliary outlet, the old cigarette lighter, and replaces the long cable and power supply from the Mini kit. It comes with the Mini USB-C cable.
Power options at a glance
| Option | Capacity | Mini connection | Rated output for the Mini | Carry-on size |
|---|---|---|---|---|
| BigBlue POWAFREE 3 | 99Wh | Dedicated DC cable or USB-C | USB-C 20V at 5A, 100W | Yes, under 100Wh |
| Jackery Explorer 100 Plus | 99.2Wh | USB-C with Starlink cable | Two USB-C ports, 20V at 5A, 100W each | Yes, under 100Wh |
| Anker SOLIX C300 DC | 288Wh | USB-C with Starlink cable | Two USB-C ports, 140W each | No |
| Starlink Mini Car Adapter | Vehicle battery | USB-C, cable included | From 12 to 24V outlets | Not applicable |
Runtime depends on load and temperature, and airline rules change, so check with your carrier before flying with a battery.
Cables and adapters
Starlink Mini USB-C Cable. The official 5 meter Mini USB-C cable replaces the long stock cable when you want to run the dish from a power bank or a USB-C wall charger. Starlink is clear on three points: it needs a 100 watt, 20 volt, 5 amp source, it is only for the Mini and should not be used to charge phones or laptops, and only the barrel jack end forms an IP67 seal. Keep the USB-C end out of the weather.
Mini Ethernet cable. For a wired connection or a mesh router, Starlink recommends its 15 meter Mini Ethernet cable through the dish's latching LAN port.
Mounts
Starlink sells a full family of official Mini mounts, all listed in its Mini accessories guide:
- Mini Roof Rack Mount: clamps to roof rack bars or rails from 12 to 48 mm thick and up to 88 mm wide, and lets you slide the dish off when you park. Starlink notes it is not meant for round profile bars.
- Mini Mobility Mount: a permanent mount for wood, fiberglass, metal and plastic with stainless steel fasteners, a waterproof seal and a 9 degree mounting angle for wet weather. Good for boats and campers.
- Mini Pipe Adapter and Flat Mount: a spare or second pipe mount that also works on a flat surface.
- Mini Wall Mount: for a home or cabin wall near the gable or fascia, with up to a 4 inch overhang.
- Mini Pivot Mount: for sloped, shingled roofs, with a swivel for fine tuning the angle.
RAM Mounts for vehicles. For a mount you can take on and off without tools, RAM makes Mini specific kits. The Tough-Mag Magnetic Mount uses a base with 10 N52 magnets under a rubber coating to hold to any ferrous metal surface. The Twist-Lock Triple Suction Mount uses three suction cups for glass and other smooth surfaces. Both use a custom Starlink Mini adapter and a ball and socket arm that RAM says sets the dish at the recommended 8 degree angle, and both are built from powder coated marine grade aluminum.
Weather and extras
Starlink Router Mini. The Mini has Wi-Fi built in, but a cabin or van can still have dead spots. The Router Mini is a compact Wi-Fi 6 dual band router that meshes with the Mini. Starlink recommends running it over the 15 meter Mini Ethernet cable for best performance. It is also one of the three setups the WaterField case is built around.
Kettle Customs Slimline Mount and cover. For overlanders, the Kettle Customs Starlink Mini Slimline Mount is a marine grade aluminum mount with a universal M8 slot base for no drill fitting on major roof rack platforms. Options include a removable 3 mm UV tinted acrylic cover that keeps dust off and lets air through, a pump style suction mount, a rubber coated magnet, and a weatherproof 12 to 30 volt step-up converter.
Build your kit
Van life
Mini Roof Rack Mount or the Kettle Customs Slimline Mount on the roof, the Mini Car Adapter for driving days, and the Anker SOLIX C300 DC for nights parked off grid. Carry the dish in the WaterField Go Case when you take it into a cafe. If you use a Veritas Vans mount, its hard travel case keeps the mount, magnets and suction cups together between rigs.
Remote work
The WaterField Go Case in the Remote Worker layout: dish in the Starlink bumper, power brick and cord, Router Mini and the Mini Ethernet cable. Add a Jackery Explorer 100 Plus or BigBlue POWAFREE 3 so you can work from a park bench or a hotel balcony and still fly with it.
Camping
The BigBlue POWAFREE 3 clipped to the dish with its kickstand, the Starlink Travel Kit for protection, and a RAM Twist-Lock suction mount for the car window on the drive in. For more ideas for the campsite itself, see our guide to Snow Peak's classic camping gear.
The bottom line
Start with a case that protects the dish, add a power source that truly delivers 20 volts at 5 amps, and pick a mount for where you will actually use it. WaterField's Go Case treats the Mini like a work tool instead of camping gear, and that is why it leads this guide.
